Power Module

Clear selection

The Power Module incorporates both a way to power your autopilot (Erle-Brain, Erle-Brain 2 or Erle-Brain 3), accessories and report battery voltage (supported only in some autopilots). All through a single and tightly included 6-pin cable that directly matches the PXF's connector. The on-board switching regulator outputs 5.3V at a maximum of 2.25A, and can be used up to 18 Volts (4S LiPo) and at a maximum of 90 amps. The Power Module is ready to use with XT60 connectors pre-fitted, and shrink wrapped for protection.

Note: The Power Module is rated at 2.25 Amps to power the autopilot's, the receiver and peripherals (GPS, Telemetry radio, etc.). To power servos use an ESC with an adequate BEC or a standalone BEC plugged into the output bus.

Category: ,
Name Values
Max input voltage 18V
Max Current Sensing 90A
Switching regulator outputs 5.3V at 2.25A max
DF13 Molex cable plugs directly to Erle-brain
Voltage and current measurement configured for 5V ADC
DF13 6 Position Connector 150mm long
Power Module with XT60 Connectors

Weight 0.050 kg